Simulation and optimization of the crankshaft production line based on “One-Piece Flow” cell production mode

doi:10.16731/j.cnki.1671-3133.2018.03.016

Modern Manufacturing Engineering ›› 2018, Vol. 450 ›› Issue (3): 86-92.doi: 10.16731/j.cnki.1671-3133.2018.03.016

Previous Articles Next Articles

Simulation and optimization of the crankshaft production line based on “One-Piece Flow” cell production mode

Hu Mingmao,Li Feng

Dept.of Mechanical Engineering,Hubei Automotive Industries Institute,Shiyan 442002,Hubei,China

Received:2016-12-12 Online:2018-03-20 Published:2018-07-19

Abstract

Abstract: According to the characteristics of air compressor crankshaft machining workshop,“One-Piece Flow” cell production mode and Flexsim simulation were adopted to solve the production line layout problem.The original layout of workshop of the simulation model is established by Flexsim,found unreasonable phenomenon and proposed improvement strategy.Then combining the “One-Piece Flow” cell production mode,determine the optimal facility layout scheme.Example analysis shows:the combined “One-Piece Flow” cell production mode and Flexsim simulation can reduces the stock of semi-manufactured goods and improves production efficiency.

Key words: air compressor crankshaf, cell production, one-piece flow

CLC Number:

F273

Hu Mingmao,Li Feng. Simulation and optimization of the crankshaft production line based on “One-Piece Flow” cell production mode[J]. Modern Manufacturing Engineering, 2018, 450(3): 86-92.

References

Related Articles 15

[1]	. [J]. Modern Manufacturing Engineering, 2023, 511(4): 13-20.
[2]	. [J]. Modern Manufacturing Engineering, 2022, 505(10): 140-147.
[3]	. [J]. Modern Manufacturing Engineering, 2020, 474(3): 33-38.
[4]	. [J]. Modern Manufacturing Engineering, 2020, 474(3): 39-46.
[5]	. [J]. Modern Manufacturing Engineering, 2020, 476(5): 39-47.
[6]	. [J]. Modern Manufacturing Engineering, 2020, 475(4): 18-22.
[7]	. [J]. Modern Manufacturing Engineering, 2020, 475(4): 27-35.
[8]	. [J]. Modern Manufacturing Engineering, 2020, 475(4): 83-89.
[9]	. [J]. Modern Manufacturing Engineering, 2020, 478(7): 88-93.
[10]	. [J]. Modern Manufacturing Engineering, 2020, 482(11): 33-40.
[11]	. [J]. Modern Manufacturing Engineering, 2020, 482(11): 99-105.
[12]	. [J]. Modern Manufacturing Engineering, 2020, 481(10): 83-90.
[13]	. [J]. Modern Manufacturing Engineering, 2020, 483(12): 25-35.
[14]	. [J]. Modern Manufacturing Engineering, 2020, 483(12): 41-48.
[15]	Wang Guiyong, Zhou Ermin. The path planning based on improved genetic algorithm for “water spider” under stack scheduling strategy [J]. Modern Manufacturing Engineering, 2019, 460(1): 38-42.

Simulation and optimization of the crankshaft production line based on “One-Piece Flow” cell production mode

PDF

Knowledge

Abstract

Cite this article

share this article

References

Related Articles 15

Recommended Articles

Metrics

Comments